eSUN 1.75mm Black PLA PRO (PLA+) 3D Printer Filament 1KG Spool (2.2lbs), Black

eSUN 3D Printer Filament: PLA PRO (PLA+)

Color: Black

Extrusion Temperature Range: 205 to 225

PLA PRO(PLA+) Advantages:

Superb layer bonding
High rigidity. Good glossiness.
Several times tougher than PLA
Smoother finished printouts.
No cracking or brittle problem.
Prints are hard to break.

PLA PRO(PLA+) print temperature is about 20 Celsius higher than regular PLA. Most users print at around 210 to 215 Celsius. Other settings are about the same.

INTSERVO is dedicated to customer satisfaction. Customers are always welcome to contact us for any questions and/or support needs.

Product Features

  • 1KG net (approximately 2.2 lbs) Filament with Clear Spool
  • eSUN PLA PRO 3D Printer Filament Vacuumed Sealed With Desiccant. Superb layer bonding. Several times stronger than PLA.
  • 1.75mm Filament Diameter (Dimensional Accuracy +/- 0.05mm)
  • Recommended Extrusion/Nozzle Temperature 205C – 225C
  • Spool Diameter: 8″ – Spool Width: 2.50″ – Spool Hub Hole Diameter: 2.05″ – Inner Circle Diameter: 3.5″

Click Here For More Information

Published by

Best 3D Printer

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.

2 thoughts on “eSUN 1.75mm Black PLA PRO (PLA+) 3D Printer Filament 1KG Spool (2.2lbs), Black”

  1. Great Filament, Eh Color – Red I personally love the eSUN PLA+/PLA Pro series filament. I’ve used the red, black, and blue. All printed out beautifully once I found the perfect settings. I’ve found this prints cleaner than other PLA’s like Hatchbox, especially at lower resolutions. My only complaint is, the color on the red was eh. It looked a tad on the orange side before printing, and definitely looked like an orange-red after prints. Still wonderful to print with, but doubt I’ll get more of the red color. Luckily I…

  2. Much better than regular PLA This was my first time buying PLA+ and I have to say that it is indeed a lot less brittle than regular PLA. My only complaint was the diameter of the filament changed a lot over the length of the roll. I found the need to keep checking it before every print. This is definitely not normal for ESun filament and is one reason why I have mainly used ESun since first starting out 3D printing over two years ago. Usually I would measure the diameter once or twice and that would be good for the entire…

Leave a Reply

Your email address will not be published. Required fields are marked *