Heat Bed Power Module, 2-Pack 3D Printer Hot Bed Power Expansion Board/Heatbed Power Module/MOS Tube High Current Load Module with Cables

Heated Bed Power Module Features:
Helps 3D printer equipped with the controller board (capable of max 15A) become more powerful.
With this add-on module to board lead the maximum current up to 25A.
If you intend to use heated bed with your 3D printer that uses a 12V power supply, then this module is recommended, else it may cause excessive current during times which may burn the connectors on the controller board.
This module is based on power MOSFET and will allow PID control of the heated bed (DC-DC Relays usually do not allow this)

Specifications:
Color: Black
Max Current: 25A (Enhance heat dissipation)

Note:
1.This module under the premise of normal cooling, found at I (Max) = 25A stable work situation, the process of using the current not exceed 25A.
2.Please double-confirm the wire you connect is right when installing this MOSFET Board, if you have any issue please contact us firstly, thanks!

Packing Included:
2 x Heated Bed Power Expansion Module (motherboard is not included)
2 x Connection cable for input signal

Product Features

  • This high power module is a general add-on heated bed power expansion module for 3D printer. Effective to resolve the hot bed power is too large and the load current problems. It compatible with Anet A8 and most 3d printers.
  • The heat bed power module can be used in both Chitu motherboard and other open 3D printer motherboards.
  • With this add-on module to your controller board, you can lead the maximum current up to 25A. If you need anything greater or equal to 15A this module is a must!
  • When using heated bed 3D printer for 12V power supply which may cause excessive current during times, with this module, it can well protect the connectors on the controller board from burning.
  • Note: Under the premise of normal cooling, it works stably under I(Max)=25A, the current must NOT exceed 25A while in the work process.

Click Here For More Information

2-Pack NEMA 17 Stepper Steel and Rubber Vibration Dampers for 3D Printer, CNC

These vibration dampers are a great motor mount accessory for 3D Printers, CNC, or other hardware that uses NEMA 17 steppers or electrical motors. Installed between your stepper and the mount with the original screws, they will drastically reduce noise and vibration transmitted through the machine. Reduced noise and vibration results in higher 3d print speeds with fewer mechanical artifacts.

Product Features

  • Nema17 Stepper Dampers are used to decrease noise and resonance in your CNC and 3d Printer.
  • 1 Damper used per Stepper or Electric motor
  • 3d Printers see a 5-10dB reduction in noise when used on X and Y Axis steppers
  • Works on both Cartesian and Delta style Additive Manufacturing machines
  • Pair these with good filament for the best results in your 3D printer and remove vibration and noise.

Detailed Information available on our Homepage…

Nozzle 0.4-6 Corners for Afinia 3D Printer 2-Pack

Nozzle 0.4-6 Corners for Afinia 3D Printer 2-Pack

Product Features

  • Nozzle 0.4-6 Corners for Afinia 3D Printer 2-Pack

Detailed Information available on our Homepage…