- Molded plastic handle
- Hang-up hole in handle for convenient storage
- Brass fill material in 3×7 rows
Step 1: To remove prints off the bed, work the edge of the tool under a corner of the print, approximately half way between the tip of the blade and the handle.
Step 2: Use a sawing motion to get the tool under the rest of the print to separate it from the bed. Tilting or twisting the blade slightly will help speed up the lifting of the print.
Step 3: If the print is firmly stuck to the print bed, try pushing the tool so that the handle is closer to the print. This brings the thicker part of the blade (closest to the handle) under the object and acts as a wedge to help pry the part up. Wiggle the blade loose and repeat.
Step 4:If the print is stuck too firmly to remove with the tool, you may need to slightly increase your starting nozzle elevation. The idea is to have the print stick firmly to the bed during printing, but still be removed with the tool.
Step 5: If the nozzles blocked, check the size of output diameter and choose the correct needle. Then, clean the nozzles by cleaning needles and tweezers.
Wide Compatibility – Compatible with most of 3D Printer 0.4mm nozzle such as Makerbot Creality, CR-10, CR10, Ender 2, Ender 3, Anet A8, Tevo, Tarantula, Lulzbot, MK8, Reprap, E3D, V6, Volcano, Prusa I3, Prusa MK2, Prusa MK2S, Prusa MK3, and much more.
1.The needles aremade of quality stainless steel, flexible and won’t break easily, with a handlefor easily twisting.
2.The tweezershave Fine tips with non-magnetic coating. Great for repairing small wires,screws, circuit board welding.
3.Reaching where your fingers can’t.Suitable for high-density integrated circuit chip within the operation.
4.Wide suitable:Compatible with most of 3D printers on the market such as Duplicator, MakerBot,RepRap etc.